Add automations to your check rules
Link existing automations or create one from a Dash0 template without leaving the check rule, and choose how the alert and the automation's result are delivered.
When a check fails, an automation can investigate it for you. Until now, you set one up on the Automations page and then had to work out which check rules it covered.
A check rule now has an Automations section after its Notifications. It lists the automations that run when the rule fails. You can link an existing automation, or create one from a Dash0 template, such as Investigate, without leaving alerting. Before you create it, the template panel shows how many runs and credits to expect each month. If an automation runs for every failed check or matches by label, you can stop it for a single rule. Linking works even on rules you can only read, as long as you can create automations.
For each pair of check rule and automation, you choose how the alert and the automation's result are delivered:
- Same notification channel, when automation finishes: the alert goes out as usual, and the result follows as a new message. This is the default.
- Hold off the alert until the automation completes: one alert goes out, with the result, when the run finishes.
- Different notification channels: the alert goes to the check rule's channels, and the result goes to the automation's Send to.
A held alert is still sent if the run is skipped or fails. Results follow silences, so a silenced failed check does not leak into your channels.
See About Automations to learn more.